[flashboot] Booting with 5.0 image
Eric Boudrand
eric.boudrand at caramail.com
Tue Jan 31 22:36:16 EST 2012
Hi,
I have tested SOEKRIS4521-50.image on a Soekris NET4511. The boot
sequence failed with this log :
boot>
booting hd0a:/bsd: 53407060+463132 [61+127216+116991]=0x339ba3c
entry point at 0x200120
[ using 244684 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2011 OpenBSD. All rights reserved. http://www.OpenBSD.org
OpenBSD 5.0 (SOEKRIS4521) #0: Wed Nov 2 12:07:42 MDT 2011
root at i386.builder:/obj/SOEKRIS4521
cpu0: AMD Am486DX4 W/B or Am5x86 W/B 150 ("AuthenticAMD" 486-class)
cpu0: FPU
real mem = 66646016 (63MB)
avail mem = 12173312 (11MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 20/31/19, BIOS32 rev. 0 @ 0xf7840
pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc8000/0xa000
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
elansc0 at pci0 dev 0 function 0 "AMD ElanSC520 PCI" rev 0x00: product 0 steppi>
gpio0 at elansc0: 32 pins
cbb0 at pci0 dev 9 function 0 "TI PCI1410 CardBus" rev 0x02: irq 10
sis0 at pci0 dev 18 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 11, 8
nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1
sis1 at pci0 dev 19 function 0 "NS DP83815 10/100" rev 0x00, DP83816A: irq 5, a9
nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 1 device 0 cacheline 0x10, lattimer 0x3f
pcmcia0 at cardslot0
isa0 at mainbus0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
wdc0 at isa0 port 0x1f0/8 irq 14
wd0 at wdc0 channel 0 drive 0: <SanDisk SDCFH-004G>
wd0: 1-sector PIO, LBA48, 3815MB, 7813120 sectors
wd0(wdc0:0:0): using BIOS timings
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
Any suggestion is welcome.
Regards.
Éric Boudrand
More information about the flashboot
mailing list